Konica Minolta bizhub PRESS C8000e - Manual (Page 149)

bizhub PRESS C8000 5-15
5.5 Eliminating Copy Marks Along Borders: Frame Center Erase 5
5.5 Eliminating Copy Marks Along Borders: Frame Center Erase
When the original is scanned from the original glass, black copy marks may be produced along borders and
center line, and also around punch holes. Use this function to eliminate them from the copies and lower the
toner consumption at the same time.
You can also use the ADF to eliminate black copy marks along borders and center line, for the original avail-
able in the ADF.
0 Available range for the Frame Erase amount is 1 to 300 mm, for the Center Erase amount is 1 to 99 mm,
in 1 mm increments.
0 Frame Erase and Center Erase can be used in combination.
0 Frame Erase provides [Erase/All Sides] that erases specified amount collectively for all four sides, and
[Erase/Each Side] to specify an erasure amount individually for each side.
1
Position the original.
Position the original on the original glass.
For the black-marked original available in the ADF, position it in the ADF.
NOTICE
When lowering the ADF onto thick original (e.g. open book) placed on the original glass, do not press
it down too hard. Keep the ADF open, if required.
2
Press [Application] on the Copy Screen.
3
Press [Frame Center Erase] on the Application Screen.
Setting options Description
Frame Erase Erases black copy marks along borders of the original image.
Center Erase Erases black copy marks along the center line of the original.