INFICON 3000 Micro GC Gas Analyzer Reference Guide - Manual (Page 99)

22 - 1
PN
07
4-
55
8-
P1
A
3000 Micro GC Guides
3000 Micro GC Guide 22
Installing the Digital I/O Module
Table 22-1 Installing the digital I/O module
Step Description
1 For some applications, an external triggering device may be required for sampling. Install the
Digital I/O Module (PN G2847A) in 3000 Micro GC and connect it to the external triggering
device via a Remote Start Cable (PN G2801-60618).
NOTE: A 4-channel 3000 Micro GC is displayed below.
2 The digital I/O kit contains the following items:
3 The following tools are required to install the digital I/O module (not provided):
• Torx T-10 driver
• Torx T-20 screwdriver driver
• Needle nose pliers (helpful for disconnecting cables)
• Phillips Head Screwdriver
• Flat-bladed screwdriver