INFICON SQM-160 Thin Film Deposition Monitor User Manual
Page 64
5 - 4
IP
N 07
4-
51
1-
P1
C
SQM-160 Operating Manual
Select the button for Use the following IP address, enter the IP address and
Subnet mask shown in
, and press OK. With this selection, the PC is
assigned an IP address to use when communicating with the SQM-160. The
SQM-160 is shipped from INFICON with a pre-assigned address of 192.168.1.200.
To communicate directly with the SQM-160 from a PC, the PC must also be
assigned an address that starts with 192.168.1 but cannot be set to 192.168.1.200.
The example in
uses the address 192.168.1.201 for the PC.
Figure 5-4 Entering the IP Address and Subnet mask
Click OK to all open dialogs to close out the Internet Protocol setup for the Local
Area Connection. Open the SQM-160 software and confirm that you have
communications.