INFICON SQM-160 Thin Film Deposition Monitor User Manual
Sqm-160, Multi-film rate/thickness monitor
Advertising
Table of contents
Document Outline
- Cover Page
- Title Page
- Trademarks
- Disclaimer
- Copyright
- Declaration Of Conformity
- Warranty
- Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Quick Start
- Chapter 3 Operation
- 3.1 Introduction
- 3.2 Menu Selection
- 3.3 Film Menu
- 3.4 System Menu
- 3.5 Sensor Selection
- 3.6 Sensor Frequency
- 3.7 Sensor Tooling
- 3.8 Display Units
- 3.9 Crystal Life
- 3.10 Zero Thickness
- 3.11 Shutter Operation
- 3.12 Dual Sensors
- 3.13 Rate Sampling
- 3.14 Time Setpoint
- 3.15 Thickness Setpoint
- 3.16 Simulate Mode
- 3.17 Defaulting the Memory
- 3.18 Relay Operation
- 3.19 Analog Output Configuration
- 3.20 I/O Connections
- 3.21 Rack Mounting Procedure
- Chapter 4 SQM-160 Comm Software
- Chapter 5 Communications
- 5.1 Introduction
- 5.2 SQM-160 Comm Software
- 5.3 SQM-160 Communications Protocol
- 5.4 Commands
- 5.4.1 Command: @
- 5.4.2 Command: A
- 5.4.3 Command: B
- 5.4.4 Command: C
- 5.4.5 Command: D
- 5.4.6 Command: J
- 5.4.7 Command: L
- 5.4.8 Command: M
- 5.4.9 Command: N
- 5.4.10 Command: O
- 5.4.11 Command: P
- 5.4.12 Command: R
- 5.4.13 Command: S
- 5.4.14 Command: T
- 5.4.15 Command: U
- 5.4.16 Command: W
- 5.4.17 Command: Y
- 5.4.18 Command: Z
- 5.5 CRC Examples
- Chapter 6 Troubleshooting and Maintenance
- Chapter 7 Calibration Procedures
- Chapter 8 Measurement and Theory
- Appendix A Material Table