3 setting the station address, 1 setting the station address via dip switches, Setting the station address – Lenze E84Dxxxx User Manual
Page 24: Setting the station address via dip switches, Communication manual 8400 protec profibus
Advertising
EDS84DPBUS EN 2.0 - 09/2010
L
24
Communication manual 8400 protec PROFIBUS
Commissioning
Setting the station address
5.3
Setting the station address
The station addresses must differ from each other in case of several networked PROFIBUS
nodes.
The station address can be set via DIP switch SW1 or via the »Engineer« (code
).
5.3.1
Setting the station address via DIP switches
The DIP switch SW1 for setting the station address is under the service cover.
[5-1]
Position of the DIP switch
Defining the station address by ...
DIP switch
C13899
Condition
at least one switch 1 … 64 = ON
Switches 1 ... 64 = OFF (Lenze setting)
Advertising