2 setting the station address via the »engineer, Setting the station address via the »engineer – Lenze E84Dxxxx User Manual
Page 26
Advertising
EDS84DPBUS EN 2.0 - 09/2010
L
26
Communication manual 8400 protec PROFIBUS
Commissioning
Setting the station address
5.3.2
Setting the station address via the »Engineer«
In the »Engineer«, the station address is set under the Settings tab.
Valid address range: 1 … 126 (max. 125 slave nodes)
Impermissible addresses are indicated in red in the Station address input field.
Save the changed settings with the device command C00002 = 11 (save all parameter
sets).
Advertising