SATEC EM920 Operation Manual - Manual (Page 152)

Chapter 8 Retrieving and Storing Files
Using the Upload Scheduler
152 EM920 Power Quality and Revenue Meter
3. Click Browse and select a database for storing
retrieved data, or type the name for a new database,
select a directory where you want to save it, and then
click OK.
4. Click Configure or double click on the site row.
5. Select a daily, weekly or monthly schedule, and adjust
the start time. If you wish to upload data periodically
in predefined intervals, click on “Periodic” and define
the time period in hours and minutes.
6. Select the number of attempts to upload data in the
event of temporary communication problems or
unavailability of your device, and the delay between
attempts in minutes and seconds.
7. If you wish to use the schedule to synchronize the
device clock with your PC, check the “RTC
Synchronization Enable” box. If your device is
password protected by a communications password,
type in the password you set in the device to allow
PAS to update the clock.
8. Click on the Select Logs button, check the boxes for
logs you want to upload on a schedule, and then click
OK.
9. Check the Enabled box at left to activate a schedule
for the device.
10. Click Close to store your schedule.
To keep the Upload Scheduler running, the On-line button
on the PAS toolbar must be checked all the time. If you
uncheck it, the scheduler stops operations. This does not
cause loss of data, since the scheduler will resume operations
when you check this button again.