SATEC EM920 Operation Manual - Manual (Page 32)

Chapter 3 Using Front Display
Display Operations
32 EM920 Power Quality and Revenue Meter
The TEST Button
The TEST button can be accessed by removing a meter cover.
Pressing the TEST button for more than 2 seconds moves you
to the test mode menu where you can switch the operating
mode or change the test LED pulse rate. See
TEST Mode in
Chapter 2 for more information on TEST mode operations.
Navigating in Data Display Mode
The following table gives a summary of the button operations
in data display mode.
Button Press Operation
SCROLL Short press Scrolls through pages
SELECT/ENTER Short press Scrolls through displays
SCROLL + SELECT/ENTER Short press Returns to the start page within
a present display
SCROLL + SELECT/ENTER
(in the present billing period
page)
Short press Enters to/Return from the test
display
SCROLL + SELECT/ENTER
(in selected pages) Extended press Shortcut for entering a specific
menu in programming mode
SELECT/ENTER Extended press Enters programming mode
TEST (under cover) Press for more
than 2 seconds Enters the test mode menu
RESET (sealable) Press for more
than 2 seconds Enters the maximum demand
reset menu (locked in TEST
mode)
Resets test energy registers in
the TEST mode data display
The EM920 provides 12 different multi-page data displays.
Your present location is indicated by three numbers at the
right on the status bar as shown in the following picture. See
Data Displays for the full displays list and enumeration.
Use a short press on the SELECT/ENTER button to scroll
through data displays. Use a short press on the SCROLL
button to scroll through the display pages.
Display page number
Number of pages in the present display
Data display number