SATEC EM920 Operation Manual - Manual (Page 69)

Chapter 5 Configuring the EM920
Configuring Communications
EM920 Power Quality and Revenue Meter 69
Parameter Options Default Description
SNTP Client Enabled NO, YES NO Enables operations of the SNTP
client
Polling interval, s 60-86400 s
600 s The time remaining requesting
time from the SNTP server
Primary SNTP Server IP
Address 192.36.143.151 The IP address of the primary
SNTP server
Secondary SNTP Server
IP Address 130.149.17.21 The IP address of a secondary
SNTP server in the event of
temporary unavailability of the
primary server.
The default SNTP server IP addresses belong to Stockholm
and Berlin university servers.
Setting-Up eXpertPower Client
Select Communication Setup from the Meter Setup menu,
and then click on the ExpertPower Client Setup tab.
The EM920 has an embedded eXpertPower TM client that
provides communications with the eXpertPower TM server –
the SATEC proprietary Internet services. Connections to the
eXpertPower
TM server are handled on a periodic basis.
The following table lists available options. Refer to your
eXpertPower service provider for the correct eXpertPower
settings.
Parameter Options Default Description
XPW Server IP Address 207.232.60.18 The IP address of the
eXpertPower server
XPW Server Port 0-65535 5001 The TCP service port of the
eXpertPower server