Continuous read mode, Stop continuous read, Teach continuous read – Rockwell Automation 56RF RFID System User Manual User Manual
Page 108
108
Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011
Chapter 9
RSLogix 5000 Code Examples
Upon successful completion of the write block command, the Input Image table
shows that Command = 10 and ChError = 0. The input channel data fields are
all zero.
Use the Read Single Block command (=1) , with option flag set to zero, to read
the contents of the tag in block 3.
Continuous Read Mode
The Continuous Read command is used for specialty applications requiring high
line speeds (up to 3 m/s). Refer to
Continuous Read Mode on page 120
for
details on this command.
Stop Continuous Read
The Stop Continuous Read command is used in conjunction with the
Continuous Read command for specialty applications requiring high line speeds
(up to 3 m/s). Refer to
Continuous Read Mode on page 120
for details on this
command.
Teach Continuous Read
The Teach Continuous Read command is used to train the interface for
Continuous Read operations. Refer to
Teach Continuous Read on page 123
for
details on this command.