Rockwell Automation 56RF RFID System User Manual - Manual (Page 87)

Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011 87
RSLogix 5000 Code Examples Chapter 9
Example Results
The following figure shows an example of results where the Option Flag was set
to 1, which reads the UUID.
The UUID is loaded into Data[0] through Data[7]. The user data (1, 2, 3, 4, 5,
6…) begins in Data[8]. The figure below only shows a partial listing of the user
data. The command read in 112 bytes of data.
In the figure below, the command was repeated with the Starting Address set to 2
and the number of bytes set to 3.