Rockwell Automation 56RF RFID System User Manual - Manual (Page 29)

Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011 29
Chapter
3
Electrical Installation
Cable Overview The EtherNet/IP switch must be mounted inside a control panel. The Bul. 56RF
EIP interface block and Bul. 56RF transceivers can be mounted on the machine.
Figure 6 - Transceiver Mounting
Three types of cables are needed.
1. This is an EtherNet cable, RJ45 to M12-QD patchcord.
2. This is a 5-pin M12 to 5-pin M12 patchcord. The cable includes a shield
that connects to the functional earth point on the interface block.
3. This is a 4-pin female micro QD cordset that connects power to the
interface block.
56RF
Interface Block 1783-US05T
Ethernet/IP Switch 56RF
Transceivers
2
3
4
5
1
P
W
R
1783-US05T
Mounted
in a Cabinet Mounted
on the Machine
1
2
3