Rockwell Automation 56RF RFID System User Manual - Manual (Page 55)

Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011 55
Add Your RFID Interface Block to an RSLogix 5000 Program Chapter 6
Internet Protocol Tab For the purposes of this user manual, the user is expected to use a Private Address,
that is, and address of 192.168.1.xxx. This window is automatically populated
with the data.
Port Configuration Tab The Port Configuration fields should not need to be changed for the Quick Start
process. These fields only become active when the controller is on line.
The number of ports showing in this window will vary depending on the block
used. There should be either one or two ports.
The following window shows two ports. Port 1 is active, while Port 2 is inactive.