Rockwell Automation 56RF RFID System User Manual - Manual (Page 33)

Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011 33
Electrical Installation Chapter 3
EtherNet I/P Connection
The D-Code M12 connector on the interface block is shown in the figure below.
Use the Cat. No. 1585D-M4DC-H (polyamide small body unshielded) or the
Cat. No. 1585D-M4DC-SH (zinc die-cast large body shielded) mating
connectors for the D-Code M12 female network connector.
Use two twisted pair Cat 5E UTP or STP cables.
The 56RF interface block encoders can be connected in either of three network
topologies: star, linear or Device Level Ring (DLR).
Pin Function
1 Tx+
2 Rx+
3 Tx-
4 Rx-
5 Connector shell connected to FE
D-Code M12 Pin Wire Color Signal 8-Way Modular
RJ45 Pin
1 White-Orange Tx+ 1
2 White-Green Rx+ 3
3 Orange Tx- 2
4 Green Rx- 6
4
2
3 1 5