Rockwell Automation 56RF RFID System User Manual - Manual (Page 54)

54 Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011
Chapter 6 Add Your RFID Interface Block to an RSLogix 5000 Program
Module Info The Module Info tab contains read only data that is populated when the
controller goes on-line (a program is downloaded to or uploaded from the
controller).
In the left panel, the AOP shows the vendor, product type, product code.
Revision level, serial number, and product name.
In the right panel, the AOP shows the fault status, internal state (i.e., Run mode),
and whether the file is owned and Module Identity.
The Refresh and Reset Module button are active when the controller is online.
• Refresh – Click this button to refresh the data in the window.
• Reset Module – Click this button with care as it disconnects the module
momentarily and control will be interrupted. The following warning
window appears.
Click Yes or No as needed. Click Help for further information.