Rockwell Automation 56RF RFID System User Manual - Manual (Page 11)

Rockwell Automation Publication 56RF-UM001A-EN-P - October 2011 11
Introduction Chapter 1
System Setup The figure below shows a simple RFID system. This user manual describes the
setup, installation, and programming required to get this system running.
Figure 1 - RFID System
Tags are attached to objects that need to be tracked. The tags hold important
information about the object. An RF transceiver reads and/or writes information
to the tags when the tag moves within the transmission envelope of the
transceiver (dotted ellipse). The physical size of the transceiver is directly related
to the size of the transmission field. The larger the transceiver, the longer and
wider the antenna field is. Please see transceiver instruction sheets for antenna
field sizes.
The transceivers are connected to a special RFID EIP interface block. The
distribution block has an EtherNet connection to an EtherNet switch. An L35E
CompactLogix controller and a personal computer also have EtherNet
connections to the EtherNet switch.
ET H ER N ET /I P
NS MS LINK
56RF
Interface Block
Personal
Computer
L35E
CompactLogix
1783-US05T
Ethernet/IP
Switch
56RF
Transceiver
56RF
Tag
56RF
Transceiver
Tracked
Object
2
3
4
5
1
P
W
R
1783-US05T