Configure the devicenet network, Introduction, Configuration – Rockwell Automation 193-DNENCATR EtherNet/IP Communications Auxiliary User Manual User Manual
Page 31: Chapter 3, Introduction configuration
Advertising
Rockwell Automation Publication 193-UM014B-EN-P December 2011
31
Chapter
3
Configure the DeviceNet Network
Introduction
The purpose of this chapter is to assist in configuring the DeviceNet Network
with the EtherNet/IP Communications Auxiliary. A DeviceNet network can be
configured using the internal web interface from the EtherNet/IP
Communications Auxiliary.
Configuration
1.
From the web page, navigate to Scan List>Configuration>Advanced.
2.
If desired, change the baud rate using the DeviceNet Baud Rate pull-down
menu. The default value of 125K for the DeviceNet network.
NOTE:
Autobaud is not supported with this product.
Advertising
This manual is related to the following products: