Rockwell Automation 193-DNENCATR EtherNet/IP Communications Auxiliary User Manual - Manual (Page 39)

Rockwell Automation Publication 193-UM014B-EN-P December 2011 39
Chapter 4
4. Using the keypad on the PC keyboard, change the network node address
to the desired value. Ensure the desired value is not duplicating any other
device’s node address, then click the Apply button.
5. The following window will appear confirming a successful node address
value change. Click OK.
6. Verify the node address was changed to the desired value in the “New
settings” section of the page. Note that the “Current settings” area will still
display the old node address unitl the device is selected again from the
Network Who list.
7. Repeat steps 1 through 6 until all new or additional devices are added to
the DeviceNetwork.