Accessing module data with add-on profiles – Rockwell Automation 193-DNENCATR EtherNet/IP Communications Auxiliary User Manual User Manual
Page 56
56
Rockwell Automation Publication 193-UM014B-EN-P December 2011
Chapter 7
8.
Click OK at the next window to have RSLogix 5000 create the predefined
tags. The EtherNet/IP Communications Auxiliary will now show as a
module in the I/O Configuration folder.
Accessing Module Data with Add-On Profiles
With both the Logix controller and EtherNet/IP network configured, the Logix
controller can exchange data with the EtherNet/IP Communication Auxiliary.
1.
Open the Controller Tags window.
2.
Select the Monitor Tags tab.
In the above example, the predefined input and output tags were generated for
each of the six scanned devices. To control the output relays for the scanned
device, use the output tags. For diagnostic informaton from the device, use the
input tags.