Rockwell Automation 193-DNENCATR EtherNet/IP Communications Auxiliary User Manual - Manual (Page 9)

Rockwell Automation Publication 193-UM014B-EN-P December 2011 9
Chapter 1
Features Figure 1 - Features
Installation The EtherNet/IP Communications Auxiliary may be DIN Rail or panel
mounted. To avoid overheating, the unit must be mounted vertically and
requires 37.4 mm (1-1/2 in.) of clearance at the top and bottom to allow proper
air flow. The temperature ratings for the unit will be derated if not mounted in
this manner.
Front View
Module
Ethernet/IP
Network
Front Port Link
Rear Port Link
DeviceNet Network
Status LED
Status
LEDs
Activity
LEDs
Earth Ground Connector
DIN
Rail Mounting
DeviceNet Connector
Panel Mounting
Ethernet Connectors
RJ-45
Side View Rear View
Top View