Rockwell Automation 1775-S5_SR5,D17756.5.5 User Manual PLC-3 FAMILY I/0 - Manual (Page 168)

DH/DH+ Error Codes
Apendix B
B-3
Table B.A
Local and Reply Error Codes
Error Code Error Type Associated
Commands
Meaning
32 local all The size of the local file involved in a file assignment command is greater than
65,535 bytes.
34 local all A station number greater than 376 (octal) is specified for the remote address in
an assignment command.
35 local all Attempt to send unprotected command is invalid.
37 local all The perĆpacket timeout, set through LIST, runs out before receiving a reply. This
means that the remote station acknowledges (ACK) the command message but
does not send the reply in the allotted time (cf. error 92).
81 reply diagnostic read • A 2Ćbyte ADDR and 1Ćbyte SIZE field is missing after the FNC byte in the
command message.
• The number of bytes of data requested in the SIZE field is greater than the
maximum number allowed per reply packet (244), or SIZE is 0 (zero).
reply PLC/PLCĆ2 read • The required 2Ćbyte ADDR and 1Ćbyte SIZE field are missing in the
command message.
• The ADDR value is odd (it does not specify a word address).
• The value SIZE is 0.
• The value SIZE is greater than 244.
• The SIZE value specifies an odd number of bytes.
reply PLC/PLCĆ2 bit write Incomplete bit description because the number of bytes after the TNSW is not a
multiple of four.
reply PLC/PLCĆ2 word
write
• A 2Ćbyte ADDR field is expected after the TNSW word, but only one byte is
present.
• An odd number of data bytes in the command packet.
• The ADDR value is odd (it does not specify a word address).
reply PLCĆ3 read • More than one byte of data is after the byte address.
• Number of bytes to read is odd.
• Number of bytes to read is zero.
• Number of bytes to read is greater than the maximum allowed in a reply
packet (244).
• Sum of packet offset and size of data in words is greater than 65,535.
• Sum of packet offset and size of data in words is greater than the total
transaction size.
reply PLCĆ3 bit write More than four bytes of data exist after the address in the command message.
reply PLCĆ3 write • Less than two bytes of data are after the end of the block address.
• An odd number of data bytes is after the end of the block address.
• Sum of packet offset and size values specifies more than 65,535.
• Sum of packet offset and size is greater than total transaction size.
83 reply PLC/PLCĆ2/PLCĆ3
read and write
The local scanner has executed a shutdown request to the local PLCĆ3 controller.