Rockwell Automation 1775-S5_SR5,D17756.5.5 User Manual PLC-3 FAMILY I/0 - Manual (Page 36)

Configuring the Scanner through LIST
Chapter 2
2-10
DH or DH+ Configuration
When you configure channel 4 for DH or DH+ communication protocol,
you can set the following parameters:
node mode (page 2-11)
station number (page 2-11)
DH/DH+ timeouts (page 2-12)
backup operation (page 2-13)
send unprotected (page 2-14)
accept upload/download (page 2-15)
accept writes (page 2-15)
input file list (page 2-16)
privileges (page 2-17)
DH/DH+ switch settings (page 2-18)
DH+ active node list (page 2-19)
DH+ active nodes to status file 6 (page 2-20)
When configuring channel four for a communication protocol, the menu
contains these selections:
S5 1-CHAN 4
1 NODE MODE *ON–LINE OFF–LINE
2 STATION NUMBER: 23 SELECTED 255 ACTUAL
3 DH/DH+ TIMEOUTS
4 BACKUP OPERATION
5 *SEND UNPROTECTED
6 *ACCEPT UPLOAD/DOWNLOAD
7 *ACCEPT WRITES
8 INPUT FILE LIST
9 PRIVILEGES
10 DH/DH+ SWITCH SETTINGS
11 DH+ ACTIVE NODE LIST
12 DH+ ACTIVE NODES TO STATUS FILE 6
ENTER NEXT >
The following subsections describe these selections.