Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL - Manual (Page 10)

Chapter 2
What You Need
2–3
SLC Controller
The sample application operates with both fixed and modular style
SLC 500 Controllers.
Programmer
You can program the SLC 500 with either a:
D Hand-Held Terminal (Catalog No. 1747-PT1)
D Advanced Programming Software (Catalog No. 1747-PA2E)
on a personal computer
Note: APS software requires an Allen-Bradley T50 Industrial Terminal,
T47 Portable Terminal, IBM PC/AT or 100% compatible personal computer.
The computer requires 640K of RAM, a 10M hard drive, and DOS 3.0 or
later. APS software is provided on both 3 1/2 inch and 5 1/4 inch diskettes.
Cables
To connect the Hand-Held Terminal (HHT) to an SLC 500, use this cable:
D SLC Communications Cable (Catalog No. 1747-C10)
To connect a personal computer to the SLC 500, use the following:
D SLC Communications Cable (Catalog No. 1747-C10)
D Personal Computer Interface Converter (Catalog No. 1747-PIC)
SLC Hardware
SLC 501 SLC 500
APS Software on
Hand-Held Terminal Personal Computer