Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL - Manual (Page 14)

A–B
4
Chapter
4–1
Installing DTAM Plus Programming Software
This chapter shows how to install the DTAM Plus Programming Software
(Catalog No. 2707-NP) on your personal computer.
You should have at least 640K available RAM to run the DTAM Plus
Programming Software on your computer. Check the available RAM on
your computer using the CHKDSK command.
This section shows how to install the software on a personal computer with
at least 1 hard drive and 1 floppy or micro drive. The software is supplied on
both 5
1 /
4
and 3 1 /
2
inch disks. Use the size appropriate for your computer.
1. Turn on your computer. Your computer will display the currently active
drive: A:, B:, or C:
2. Insert the installation diskette for the DTAM Plus Programming Software
into the floppy drive.
3. Select the drive containing the diskette (A: or B:) and press [Return].
Normally this is the A: drive.
C:> a: [Return]
A:>
4. Type install and press [Return] to start the installation.
A:> install [Return]
The following screen appears:
Chapter Objectives
Checking
Available Memory
Installing DTAM Plus
Programming Software