Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL - Manual (Page 71)

A–B
8
Chapter
8–1
Running the Application
This chapter shows how to:
D Set DTAM Plus DIP Switches
D Connect the DTAM Plus to an SLC Controller
D Run the application
To run the application with an SLC 500, set the DTAM Plus DIP switches as
shown in Figure 8.1.
Access DIP switches by removing the plug from the access hole on the back
of the DTAM Plus.
Figure 8.1
Typical DIP Switch Settings for SLC Operation
SW-1
OFF OFF OFF
ON ON
1 2 3 4 5 6
1 2 3 4 5 6
Back of DTAM Plus
OPEN
ON =
Side View
ON
Chapter Objectives
DTAM Plus DIP
Switch Settings