7 - slc application file, Chapter objectives, Configuring the slc 500 – Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL User Manual
Page 67: Preloaded values, Slc application file
A–B
7
Chapter
7–1
SLC Application File
This chapter provides the ladder logic program required to run the DTAM
Plus sample application.
You can program an SLC 500 using either of the following:
D Advanced Programming Software (APS) on a personal computer
D Hand-Held Terminal
This manual does not provide instructions on how to program the SLC
controller. Refer to the User Manuals for the equipment you are using.
Included in this chapter is the logic program you need to enter.
To provide values for the sample program, the data below must be loaded
into the following SLC data files.
Address
0
1
2
3
4
5
6
7
8
9
N10:0
0
30
77
122
144
179
222
245
259
278
N10:10
301
322
367
378
399
488
512
533
542
588
N10:20
601
544
566
567
533
521
524
500
433
333
N10:30
288
266
211
197
155
140
98
55
11
0
N10:40
0
3
8
12
14
18
22
25
26
28
N10:50
30
32
37
38
40
49
51
53
54
59
N10:60
60
54
57
57
53
52
52
50
43
33
N10:70
29
27
21
20
16
14
10
6
1
0
N10:80
0
0
1
1
5
5
5
5
1
5
N10:90
5
1
1
5
5
4
4
0
5
5
N10:100
4
5
0
4
5
5
5
4
0
0
N10:110
0
0
0
0
0
0
0
0
0
0
N10:120
0
Chapter Objectives
Configuring the SLC 500
Preloaded Values