Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL - Manual (Page 8)

A–B
2
Chapter
2–1
What You Need
This chapter describes the hardware and software needed to run the sample
application including:
D Personal Computer
D DTAM Plus Programming Software
D DTAM Plus Hardware
D SLC Hardware with Programmer.
A personal computer is required to enter and load an application into the
DTAM Plus. The computer requirements are:
D IBM PC/AT or 100% compatible
D One or two floppy drives (720K minimum)
D Hard drive is recommended and required if only one floppy drive
is present
D 640K of RAM
D DOS 3.0 or later
D Serial port on COM 1 or COM 2
D Monochrome or color monitor
DTAM Plus Programming Software is used to create and download
applications to the DTAM Plus. You need DTAM Plus Programming
Software (Catalog No. 2707-NP) version 1.10 or later.
Chapter Objectives
Personal Computer
Requirements
Personal Computer
DTAM Plus
Programming Software
DPS Software