Rockwell Automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL - Manual (Page 16)

Chapter 4
Installing DTAM Plus Programming Software
4–3
7. Press [Return] to install the DTAM Plus Programming Software in the
\DPS subdirectory. The Install program creates the subdirectory.
The Install program displays status information on your screen during the
installation.
The DPS Configuration Utility screen then appears:
8. Enter your name, company name, and software serial number (on
registration card). Also, enter the monitor type and communication port
used by your computer.
9. After responding to the above questions, you are asked to confirm the
configuration. Press [Return] to accept the configuration.
10. The installation is complete. You are returned to DOS at the new
subdirectory C: \DPS>.
Go to the next chapter. You will use the DTAM Plus Programming Software
to create the sample application.
☞ You can specify another directory.
The Install program will create the
directory if it does not exist.
☞ Press [Return] at the Video Type
and Comm Port questions to
prompt the user for this information
during application development.