Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 19)

Publication 2711P-UM004B-EN-P - March 2007
Configure the Terminal as a Slave Device 19
2. In the Address Block Properties dialog, set the Start Byte to 0,
Length in Bytes to 4, and click OK.
The address block 0-3 Bytes is added under Inputs.
3. Right-click on the new address block 0-3 Bytes and select Add
Device to define the PanelView Plus terminal as the slave for the
input address block.
4. In the Device Properties dialog of the input address block, select
Node 2 and click OK.