Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 23)

Publication 2711P-UM004B-EN-P - March 2007
Configure the Terminal as a Slave Device 23
Configure the Slave Output Data
Follow the same procedure to add a slave output block to the I/O
configuration. The 1756-DNB DeviceNet scanner will scan this output.
1. On the I/O Configuration tab, right-click the Output icon and
select Add Address Block.
2. In the Address Block Properties dialog, set the Start Byte to 0,
Length in Bytes to 4, and click OK.
The address block 0-3 Bytes is added under Outputs.