Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 5)

5 Publication 2711P-UM004B-EN-P - March 2007
Preface
About This Publication PanelView Plus and PanelView Plus CE terminals with a DeviceNet
communications module support DeviceNet scheduled I/O
communications. This guide will show you how to configure
DeviceNet communications between a PanelView Plus terminal and a
ControlLogix controller.
The PanelView Plus and PanelView Plus CE terminals can operate as a
slave or a scanner on the DeviceNet network. You will learn how to
configure a PanelView Plus terminal as a slave and a scanner using
RSView Studio Machine Edition, RSNetWorx for DeviceNet software,
and RSLogix 5000 programming software.
Topics Covered Chapter 1 Overview of DeviceNet module
Provides an overview of the DeviceNet communication module for
PanelView Plus and PanelView Plus CE devices including supported
controllers and DeviceNet I/O messaging.
Chapter 2 Configure Terminal as a Slave Device
Shows how to configure your PanelView Plus terminal to operate as a
slave device on a DeviceNet network using I/O messaging. The
procedures in this chapter build on the configurations defined in
Chapter 1.
Chapter 3 Configure Terminal as a Scanner
Shows how to configure your PanelView Plus terminal to operate as a
scanner on a DeviceNet network using I/O messaging.
Appendix A Restore Configuration to Local Tab
Shows how to copy the Target tab configuration to the Local tab.
Hardware and Software
Requirements To configure applications for DeviceNet communications, you must
install the appropriate communication module on your PanelView
Plus or PanelView Plus CE terminal. You must also verify that the
correct software and firmware is installed on the development
computer.
Hardware and Software
PanelView Plus 700 to1500
PanelView Plus CE 700 to
1500
PanelView Plus
400/600
RSView Studio Version 4.0 or later Version 4.0 or later
RSView Machine Edition
Runtime Version 4.0 or later Version 4.0 or later