Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 68)

Publication 2711P-UM004B-EN-P - March 2007
68 Configure the Terminal as a Scanner
Plus output table. The Output tab shows the data mapped
correctly.
6. Click OK.
You are prompted to download the changes to the PanelView
Plus terminal.
7. Click Yes to download the configuration.
The PanelView Plus is now configured to scan the slave I/O data
in the 1756-DNB DeviceNet module.
Summary
The scanlists are now configured for both the 1756-DNB DeviceNet
module and the PanelView Plus terminal.
You are now ready to put each device in Run mode.
• For the PanelView Plus, run the Machine Edition .mer
application in the terminal.
• For the 1756-DNB module, enable the run bit in the ladder
program using RSLogix 5000 software.
TIP
If the Automap on Add checkbox was not checked, you
would need to manually map the data on the Output tab.
IMPORTANT
To change the scanlist for a device on the network, you must
place the device in Idle mode before downloading the changes.
For the PanelView Plus, you can load the application but not run
it. For the 1756-DNB module, put the ControlLogix processor in
Program mode.