Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 56)

Publication 2711P-UM004B-EN-P - March 2007
56 Configure the Terminal as a Scanner
Create an Output Alias
Similar to the input alias, you need to create an alias for the output
block.
1. Right-click the 4-7 Bytes icon under Output and select Add Alias.
2. In the Alias Properties dialog, select these properties and then
click OK to add the alias to the address block:
• Alias Data Type = DINT
• Alias Name = Scanner_Output
• Start Byte = 4
• Array Count = 1
• Initial Value = 0
If you do not enter an initial value, a warning message indicates
that default values will be used.