Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 24)

Publication 2711P-UM004B-EN-P - March 2007
24 Configure the Terminal as a Slave Device
3. Right-click the new address block 0-3 Bytes and select Add
Device to define the PanelView Plus terminal as the slave for the
output address block.
4. In the Device Properties dialog for the output address block,
select Node 2 and click OK.
Similar to the input data, the PanelView Plus terminal will
operate as a slave for the output data. The 1756-DNB scanner
will scan this output data.
A dimmed icon appears under the Output address block for
Device 02 . This indicates the PanelView Plus terminal is the
slave.