Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 53)

Publication 2711P-UM004B-EN-P - March 2007
Configure the Terminal as a Scanner 53
2. In the Alias Properties dialog, select these properties and then
click OK to add the alias to the input address block:
• Alias Data Type = DINT
• Alias Name = Scanner_Input
• Start Byte = 4
• Array Count = 1
The slave input is now configured with:
• Address block of four bytes, starting at byte 4
• Slave device on node 1, which is the 1756-DNB module
• Alias of Scanner_Input for the input address block