Rockwell Automation DeviceNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 55)

Publication 2711P-UM004B-EN-P - March 2007
Configure the Terminal as a Scanner 55
3. Right-click the new address block 4-7 Bytes and select Add
Device to define the 1756-DNB module as the slave device for
the output block.
4. In the Device Properties dialog for the output address block,
select Node 1 and click OK.
Similar to the input data, the 1756-DNB module will operate as a
slave for the output data. The PanelView Plus will scan this
output data from the module.