Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control - Manual (Page 28)

28 Rockwell Automation Publication 7000A-UM200C-EN-P - June 2014
Chapter 2 Drive Installation
Locate the exhaust hood on top of the cabinet per Figure 19 and re-install the
original cover plate previously set aside. Care must be taken that the notches on
the bottom flange are oriented toward the sides of the drive. Affix assembly to the
drive top plate. Tighten all hardware.
For drives with an acoustic hood (shown in Figure 18 ), locate the exhaust hood
(refer to Figure 20 ).
Figure 19 - Fan Hood Installation
ATTENTION: Any screws that are accidentally dropped in the equipment must
be retrieved as damage or injury may occur.
Assembled Exhaust Hood
M6 Screw (x12)
Ensure notch
orientation to sides