Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control - Manual (Page 78)

78 Rockwell Automation Publication 7000A-UM200C-EN-P - June 2014
Chapter 3 Component Definition and Maintenance
Replacing Snubber and Sharing Resistor
The snubber and sharing resistors are part of the resistor assembly located behind
the PowerCage.
1. Remove the PowerCage as outlined in PowerCage Removal on page 88 .
2. Note the connection of the leads for correct replacement.
3. Detach the leads located on the bottom of the resistor assembly.
Figure 64 - Removal of the PowerCage
4. Remove the push nuts on the end of the retaining rod. Pinch the clip
together and pull off. Pull out the retaining rod.
5. Remove two bolts and swing out the PowerCage plug-in stab assembly.