Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control - Manual (Page 30)

30 Rockwell Automation Publication 7000A-UM200C-EN-P - June 2014
Chapter 2 Drive Installation
1. Remove and discard the protective plate and associated hardware covering
the fan opening on the cabinet.
2. Remove the top cover of the fan housing and set aside.
3. Remove the shipping cover plate on the bottom of the redundant fan
assembly and discard.
4. Position the assembly over the opening, verifying the locating hole on the
housing base aligns with the front right side of the cabinet.
5. Align the mounting holes and wire harness connections.
Figure 22 - Redundant Fan Assembly Orientation
6. Affix the redundant fan assembly to the drive top plate with the M6 thread
forming screws provided.
7. Connect the fan wire harness to fan.
8. Reinstall the top cover onto the fan housing and tighten all hardware.
Installation of Integral Transformer Cooling Fan
1. Remove the protective plate covering the fan opening on the top of
Isolation Transformer cabinet and discard.
2. Locate the cooling fan on top of the cabinet. Position it over the opening
and align the mounting holes and wire harness connections.
3. Affix the fan to the drive top plate with the M6 thread forming screws
provided.
Front
Remove cover to
install housing
M6 Screw (x12)