Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 11)

Publication 2711P-UM003B-EN-P - March 2007
Install a ControlNet Communication Module 11
To replace a communication module:
1. Disconnect power from the terminal.
2. Disconnect communication cables from the communication
module.
3. Loosen the three screws that secure the communication module
to the terminal.
4. Carefully lift the communication module away from the terminal
and set aside.
5. Install another communication module by following steps 4 to 6
in the Install a communication module procedure.
ControlNet Module
Connectors This section shows the connectors on the ControlNet communication
modules.
2711P-RN15S Communication Module for PanelView Plus/PanelView Plus CE
700-1500
Diagnostic status
indicators
Allen Bradley
ControlNet
A
B
Channel A
Channel B
Network Access Port (NAP)
RJ-45 connector for temporarily
connecting programming terminals
to devices on a ControlNet network
Channel A
BNC connectors for connecting
directly to ControlNet network
Channel B
Do not connect more than one
ControlNet network to
this card.
Redundant
media BNC
connectors