Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE User Manual
Page 17
Advertising
Publication 2711P-UM003B-EN-P - March 2007
Configure Unscheduled Communications 17
6. In the ControlNet Scanner Properties dialog, set the Node
Address to 2 and click OK.
– The node represents the unique node address (1-99) of the
ControlNet communication module.
– The slot corresponds to the position of the ControlNet
communication module in the virtual backplane of the
PanelView Plus / PanelView Plus CE, which is always 01.
7. Right-click on the ControlNet network type and click Add
Device.
Advertising