Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 7)

7 Publication 2711P-UM003B-EN-P - March 2007
Chapter
1
Install a ControlNet Communication Module
Objectives This chapter shows how to:
• Install and replace a communication module on the PanelView
Plus or PanelView Plus CE terminal.
• Connect the communication module to a ControlNet network.
The communication modules are available as separate catalog
numbers for specific communication protocols.
Install Module on 700-1500
Terminals This section shows how to install a communication module on a
PanelView Plus 700-1500 or PanelView Plus CE 700-1500 devices. The
module installs over the logic module.
To install a communication module:
1. Disconnect power from the terminal.
2. If the display module is removed from panel, set the module,
display side down, on a clean, flat, stable surface to prevent
scratches.
TIP
The logic module must be attached to the display
module before you attach the communication
module.
WARNING
Do not connect or disconnect any communication
cable with power applied to this device or any
device on the network. An electrical arc could cause
an explosion in hazardous location installations. Be
sure that power is removed or the area is
nonhazardous before proceeding.