Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 55)

Publication 2711P-UM003B-EN-P - March 2007
Upgrade a 2711P-RN15S Module Firmware 55
4. In the Add Device Selection dialog, select 2711P-RN15S,
ControlNet Scanner Card for and click OK.
5. In the ControlNet Scanner Properties dialog, set the Node
Address to 2 and click OK.
– The node represents the unique node address (1-99) of the
ControlNet Communication Module.
– The slot corresponds to the position of the ControlNet
communication module in the virtual backplane of the
PanelView Plus / PanelView Plus CE, which is always 01.