Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 8)

Publication 2711P-UM003B-EN-P - March 2007
8 Install a ControlNet Communication Module
3. Remove the label covering the communication module
connector on the logic module.
4. Position the communication module over the logic module so
that the connectors on bottom of module align with connectors
on logic module.
5. To prevent Electrostatic Discharge (ESD) between the modules,
allow the communication module to touch the logic module
before making connection.
6. Push down on communication module until connectors are
firmly seated.
7. Tighten the four screws that secure the communication module
to the logic module. Tighten screws to a torque of 0.68 Nm
(6 to 8 in-lb).
Logic Module
REMOVE LABEL TO INSTALL
COMMUNICATION MODULE
Communication
Module
Connector
Logic Module