Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 6)

Publication 2711P-UM003B-EN-P - March 2007
6
ControlNet Scheduled Communications
Additional Resources For more information consult the RSView Enterprise or RSView Studio
online help.
Electronic versions of the following publications are available at:
http://www.rockwellautomation.com/literature
• PanelView Plus User Manual (2711P-UM001)
• PanelView Plus CE User Manual (6182H-UM001)
• RSView Machine Edition User Guide (ViewME-UM003)
• ControlNet Coax Tap Installation Instructions (1786-IN007)
• ControlNet Coax Media Planning and Installation Manual
(CNET-IN002)
Requirements PanelView Plus 700-1500
PanelView Plus CE 700-1500 PanelView Plus 400 or 600
RSView Studio v3.20 or later v4.0 or later
RSView Machine Edition Runtime v3.20.04.43 or later v4.0 or later
RSNetWorx for ControlNet v5.11 or later v6.0 or later
RSLogix 5000 v13.0 or later v15.0 or later
ControlNet Module Firmware 2711P-RN15S, Series A, Rev C
(firmware v3.08 or later)
(1)
2711P-RN15C, Series A, Rev A
or later
(1)
This applies to terminals that are ordered as pre-configured units with the ControlNet module.
WARNING
The ControlNet Communications Module (2711P-RN15S) will
not run with RSView ME firmware 3.20.03.43 or earlier. All
ControlNet Modules with v3.07 firmware must be upgraded to
v3.08 or later; otherwise, outputs may turn on an indeterminate
state.