Rockwell Automation 2711P ControlNet Communications for PanelView Plus and PanelView Plus CE - Manual (Page 47)

Publication 2711P-UM003B-EN-P - March 2007
Configure Scheduled Communications 47
Configure the Output Scan Size for the Module
1. On the I/O Configuration tab, right-click on Output and select
Add Address Block.
2. In the Address Block Properties dialog, set these properties and
click OK.
a. Start Byte=0
b. Length in Bytes = 4
The PanelView Plus will send 1 DINT to the ControlLogix
processor beginning at byte 0.