Bio-Rad Model 680 Microplate Reader Accessories - Manual (Page 41)

Chapter 4. Protocols
33
For example, if the labels “Date” and “Operator” are created in a Protocol File, then
when that Protocol is run, a dialog box will pop up after plate reading prompting you
to type the date and the operator’s name. Both the label (e.g., Date) and the label
contents (e.g., July 4, 1999) are printed on the report.
In the Reports dialog box, click on Labels... to open the Define Labels dialog box.
Figure 23. Define Labels dialog box.
See page 105 for information about defining labels.
After you have defined your labels, the Fill Labels... button in the Reports dialog
box will become active (see page 107). Click on this to fill in your labels.
Figure 24. Fill Labels dialog box.