Panasonic NN46240-501 - Manual (Page 136)

Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration 8 FTP, TFTP, and Xmodem
Section Description
8.1.2 8.6.2 Configuring the source
address of TFTP Client
Do as follows on the router that serves as the
TFTP server:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
tftp client-source { -a s o u r c e - i p - a d d r e s s |
-i { i n t e r f a c e - n a m e | i n t e r f a c e - t y p e
i n t e r f a c e - n u m } }
The source address of TFTP client is started.
—End
8.1.3 Downloading Files Through
TFTP
Do as follows on the router that serves as the
TFTP client:
Step 1 Run the following commands according to
different type of the server IP addresses.
• The IP address of the server is IPv4
address, run:
tftp [ -a s o u r c e - i p - a d d r e s s | -i
{ i n t e r f a c e - n a m e | i n t e r f a c e - t y p e
i n t e r f a c e - n u m } ] t f t p - s e r v e r get
s o u r c e - f i l e n a m e [ d e s t i n a t i o n - f i l e n a m e ]
The router is configured to download files
through TFTP.
• The IP address of the server is IPv6
address, run:
tftp ipv6 [ -a source-ip-address ]
t f t p - s e r v e r [ -i i n t e r f a c e - t y p e
i n t e r f a c e - n u m b e r ] get s o u r c e - f i l e n a m e
[ d e s t i n a t i o n - f i l e n a m e ]
The router is configured to download files
through TFTP.
—End
Step 2 Run the following commands accorHing to
This section describes how to limit
client access to the TFTP router.
Issue 5.3 (30 Marcl d i ff 09) nt tyP e of the ser N(rrt3i Nrii^wisikf Inc.
• The IP address of the server is IPv4
address, run:
tftp [ -a s o u r c e - i p - a d d r e s s | -i
8-3