Panasonic NN46240-501 - Manual (Page 98)

5 User management
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
Step 3 Run:
user privilege level level
This command configures the priority of the user interface.
—End
5.2.6 Configuring modem attributes
Do as follows on the router that the user logs on to:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
user-interface aux 0
The user interface view appears.
Step 3 Run:
modem timer answer seconds
This command configures the interval between the system receiving the ring signal and
waiting for CD_UP. The interval is the time from the modem answer to carrier detection.
Step 4 Run:
modem auto-answer
This command configures automatic answer.
Step 5 Run:
modem [ both | call-in ]
This command configures incoming and outgoing calls.
—End
5.2.7 Configuring an auto-execute command
A
• Use the auto-execute command command carefully because it can cause failure of the
system configuration through the user interface.
• Before you configure this command and save the configuration, ensure that you can
remove the configuration by logging on to the system in other ways, such as logging on
the router through the console port
Do as follows on the router that the user logs on to:
5-8 Nortel Networks Inc. Issue 5.3 (30 March 2009)