Panasonic NN46240-501 - Manual (Page 51)

2 Configuration environment setup
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
Configuration procedures
No. Procedure
1 Establishing the physical connection
2 Configuring terminals
3 Logging on to the router
2.2.2 Establishing the physical connection
Do as follows on the router:
Step 1 Connect the COM port on the PC and the console port on the router by cable.
Step 2 Power on all devices to perform a self-check.
—End
2.2.3 Configuring terminals
Do as follows on the PC:
Run the terminal emulation program on the PC, setting the communication parameter of the
terminal to 9600 bps, data bit to 8, and stop bit to 1. Specify no parity and no flow control.
2.2.4 Logging on to the router
Do as follows on the PC:
Press Enter until a command line prompt such as
N o r t e i
appears, and then enter the
configuration environment in the user view.
2.3 Establishing the configuration environment through
Telnet
2.3.1 Establishing the configuration task
Applicable environment
You can configure the router by local logon or remote logon through Telnet.
Preconfiguration tasks
Before you configure the router through Telnet, complete the following tasks:
• Power on devices and perform a self-check.
• Prepare the PC (including the serial port and Ethernet crossover/direct network cable).
2-4 Nortel Networks Inc. Issue 5.3 (30 March 2009)